A 1.5–3 mm veneer made from a genuine natural stone layer, bonded to a flexible backing. It bends around columns, curves and corners — with no structural load.
Flexora is not a printed imitation. It is produced by slicing a thin layer of real natural stone and bonding it to a flexible carrier. The result is a sheet 1.5–3 mm thick that can be rolled, cut with a knife and applied to surfaces where traditional stone would be impossible or too heavy.
Because it adds almost no dead load, it is the practical choice for facade renovation, curved columns, lift shafts, hotel lobbies, fireplace walls and interior feature walls — especially where the existing finish cannot be demolished.
Lobbies, reception walls, bar fronts and corridor feature walls where a natural stone look must be delivered fast and without structural work.
Fireplace surrounds, stair walls, bathroom feature walls and exterior accents on Aegean stone villas.
Refreshing ageing facades without demolition, scaffolding-heavy cladding or added load on the structure.
Columns, arches and rounded corners that rigid stone slabs cannot follow without visible joints.
Reception desks, shop fronts and accent walls that need a premium finish with a short installation window.
Matching the appearance of existing natural stone on restored buildings while keeping intervention light.
Surface preparation decides the result. We assess the substrate, correct voids and moisture, prime, then bond and seal.
Free on-site survey, measurement and itemised quote across the Aegean and Mediterranean coasts.
+90 535 399 70 47